Modular Water Tank

Make certain you have all the appropriate tools and materials you have to effectively install a Hot modular water tank. Do the essential research study before attempting to install your hot modular water tank.

First you’re going to want to switch off the gas, power, and supply of water to the tank. Then placed on a hose pipe on the bottom on the hot modular water tank to drain pipes the left over water from the tank. Now you will need to remove the inlet and outlet nipples off the modular water tank, you will have to use two monkey wrench for this.

If it’s a gas water heater utilize your 2 monkey wrench and disconnect the union, that is between the supply pipe and the inlet pipe or it may be a flared fitting. You can take the flue hat off too since the tank is not running.

Now that you tank is disconnected relocation it out of the way, and put your new one where the old one was. Ensure that you can get to all the dials a buttons correctly when you put the tank back. A great guideline is to use about 6 inches around. So this means ensure that there is absolutely nothing combustible within 6 inches of your tank. Ensure too that it sits level on the flooring, you might have to make some shims.

Put Teflon tape on the inlet and outlet nipples and then put them into the brand-new tank. Make sure that the blue enters into the cold and the red goes into the hot. Likewise make sure that the arrow indications are all pointing in the correct instructions of circulation.

Modular Water Tank

Connect versatile hoses on the inlet and outlet pipes. If you don’t see a supply turned off valve on the cold side, I would install one, simply to cover yourself. After you make certain that whatever is connected back effectively, open the valve to fill the tank up, while this is happening i would open a couple of warm water faucets simply to get some of the air out.

Put back together the gas pipelines just like they were before … you might have to change it a bit, however not too much. Make certain that you utilize Teflon tape and pipeline dope on each fitting, then tighten them back together with your monkey wrench. Grab your maker guidelines to connect the gas supply tubing. After the gas is on test all your joints, making sure that there are not leaking. You can use soapy water to assist with this; it will simply bubble for you. Then you might need to return and crank on them again.

Read more about modular water tank :